Our first build for the Smart Rifle is a varient of one of the more popular ones emerging amongst miners in the Rig during recent months. This LOK uses 2 1 1 1 3 with the Explosive Chemical Compound Oveclock. This overclock trades direct damage and total ammo for the ability to cause a localized explosion on any target that has 3 or more locks on it. You get one explosion per target, so its better to stop once you reach 3 rather than overlocking on it. You can however get multiple explosions per burst, so long as you have mutiple triple locked targets upon firing. The mods increase you total ammo and speed up your lock speed with the Shutter Speed Sensor, letting you burst trios of shots out rapidly. The Tier 3 and 5 mods are there to give you a bit more value in different scenarios. Tier 3s Electro-Chemical Rounds will deal more damage to burning and electrified targets, letting you get a bit more damage out. Tier 5 is actually set to fear frequency due to the fact that youll be outputting lots of 3 or 4 rounds bursts, letting you proc the fear effect many times in a fight. I didnt go for Electric Generator Mod since anything you hit with 3 shots is probably going to die before the electrified status would matter. Tier 2 is set to use a Macro Lens in order to reduce accidental wide angle locks from happening. This increases the likelyhood that youll get 3 locks on the same target and lets you control the explosion location better.
The secondary weapon that I use here is an old favorite of mine, from my first engineer build video, the Firestarter Deepcore PGL. The build is 1 1 1 2 1 with the Clean Sweep Overclock. The fact that this PGL focuses on igniting large groups of enemies at once allows you to take advantage of the burning bugs with your primary weapons Electro-Chemical Rounds. The inherent fear effect from the grenades also gives you the breathing room to select groupd targets for more explosion kills. It may not be complicated but it gets the job done and will save you lots of ammo if you use it often.
This LOK-1 build is pretty straight forward, relying on quick successive triple lock shots to eliminate groups of bugs without spending more ammo than needed. Unlike embedded detonators, these explosions have a radius around each bug the detonate on, allowing you to use the Macro lens to select anything in the middle of a group to take as many out as you can at once. What I like to do is fire as soon as I see a 3 on any target, repeating as many times as needed to kill the group while causing as many explosions as possible. The PGL here is for huge numbers of enemies, especially at the start of an attack or with groups of swarmers and naedocites. This lets the LOK act as a mop up tool instead of having to spend its limited ammo on the brunt of a swarm. As a few little tips for the explosions, they do a lot of damage to armor so try to repeat them on guards and praetorians and You can actually get explosions out of a single shot if you overlock 3 locks onto a single target, even if the first shot would kill it anyway. This means you can overlock swarms and naedocties to kill them and nearby bugs with explosions without using extra ammo!